Title: Feasibility Study of Monitoring Delft Geothermal Project Using Land Controlled-Source Electromagnetic Method

Mahmoud Eltayieb, Dieter Werthmüller, Guy Drijkoningen, Evert Slob

Department of Geoscience and Engineering, Delft University of Technology, Netherlands

Event: GeoKarlsruhe 2021

Date: 2021

DOI: 10.48380/dggv-kne9-ja9

Delft geothermal project (DAPwell) is a planned geothermal well doublet, where relatively cold water is going to be injected through one well into a low enthalpy geothermal reservoir to produce hot water from the other well. The volume of the cold water around the injection well will increase over time and, in the end, result in a thermal breakthrough. Thus, it is essential to trace the time-lapse change in the volume of the cold water to monitor the DAPwell efficiently. The invaded reservoir volume by the cold water is associated with a decrease in the pore fluid temperature and salinity. This increases the electrical resistivity of the geothermal reservoir, where the cold front is located. Hence, estimating the time-lapse change in the electrical resistivity of the geothermal reservoir can be used to identify the distribution of the cold water. From a theoretical point of view, the controlled-source electromagnetic (CSEM) method can be used to get information about the change in the electrical resistivity within the geothermal reservoir. In this study, we investigate the feasibility of monitoring a geoelectric model of the DAPwell using land CSEM forward modelling. The optimal source frequency is also investigated as well as the optimal source-receiver offset.

A subsurface model of the DAPwell is illuminated by a horizontal electric dipole source, which emits a sinusoidal field with many frequencies. Based on the numerical experiments, surface measurements do not pick up sufficient time-lapse signal to use them for field applications. On the other hand, the difference in the z-component of the electric field, recorded in a borehole that crosses the reservoir, allows for a feasible detection of the electrical resistivity changes within the geothermal reservoir. However, it is not determined yet if the spatial distribution of the cold water can be adequately revealed from the electric field responses, or this needs to be done through CSEM inversion.

Back to list